ITEM AC75

Commercial grade .50 cal. carbide bullet single stage resizing die for use in Hornady or RCBS ammo Master Press or any press that will take a 1-1/2 - 12 TPI thread (same thread as .50 BMG dies and presses.

Specs.

1-1/2  - 12 TPI thread.

Steel body with hardened steel guide and carbide steel sizing insert, diamond ground polished finish. The hardened steel insert guides the bullet, aligns it into the carbide sizing insert. The insert is made to a custom spec. to allow for jacket springback for a finished bullet diameter of .510.

Pusher is made of high grade tool steel which will insert into shell holder slot.

Will size bullets with pull or cut marks to proper .510 diameter and smooth out any imperfection. This die will out last regular hard steel dies many times over. Similar dies, if you can find them, usually cost $350.00 to $500.00 each.

With proper care this resizing die could last many years, similar dies have been known to properly size several 100,000 tips.

Bullets should be clean before sizing and proper sizing lube or wax should be used.

$225.00 + sh.